ideecon PROJETI EDF WITHOUT IMPELLER KIT

Product number: 9752523
Manufacturer number: 3730

€109.99*

% €179.99* (38.89% saved)

No longer available

Description "ideecon PROJETI EDF WITHOUT IMPELLER KIT"
The lively Projeti2 inspires both by its arrow-fast flight (measured speed of over 200 km/h) and by its good-natured slow flight characteristics (lands at walking pace). The low weight in flight, the sophisticated aerodynamics and the high efficiency of the propeller drive give the Projeti a very high performance potential, which has characterized the Projeti for years.
We have adapted the Projeti to the new wishes and requirements and foam the model in the new EPO show. We have reinforced the model even further by foaming around a carbon fibre reinforcement tube right from the production stage. This ensures that the Projeti can safely withstand extreme flight manoeuvres even when the engine is hot.

A 6 mm carbon tube over 300 mm long is directly foamed into the wing and gives the Projeti enormous strength. This makes it almost unbreakable in flight!

A laser-cut aluminium motor mount with two motor length stops gives the Projeti high strength at the rear fuselage and allows the assembly of BL internal rotors with 28 mm diameter up to a maximum length of 45 mm. The engine mount additionally dissipates heat from the engine and is bonded to the foam as standard. The servo shafts have been enlarged to 29 x 28 x 15 mm for the installation of larger and stronger servos.


Technical data
Wing-span (mm): 820
Flight weight approx. (g): 910
Empty weight approx. (g): -
Control: H,Q,M
Length (mm): 530
Manufacturer: IDEECON
Fuselage: EPO
Wings: EPO
Rec. engine: BL Outrunner
Rec. Battery: 3S-4S LiPo 1800-2200mAh
Version: ARF - ALMOST READY TO FLY
Airfoil: -
Flight Skill: Advanced
Build Skill: Advanced
Drive Type: Electric
Box contents
  • EPO foam model incl. aluminum motor mount and foamed 6 mm GFK solid rod
  • Fuselage nose deep-drawn part painted and milled
  • Back of the fuselage Thermoformed part painted and milled
  • Canopy deep-drawn part painted and milled
  • Turbine housing blue printed in 3-D
  • Start hook milled from GfK
  • Illustrated construction stage instructions


Videos

x