This hull holder has been specially developed for the very slim hulls of the above competition classes F3J / F5J / F3B / F5B as well as F3F models. Due to the multi-point rubber support, the model is firmly positioned. Damage to the surfaces is avoided because your model is held at a safe distance from the work surface (workbench). Servo mounting, installation and conversion work in the hull boat or on the wiring, as well as linkage mounting on the hull rear, with our hull holder your model is safely and non-slip. For very thin rear booms, a combination with the hull holder "S" is conceivable. In addition, this assembly aid is also suitable for mobile use during model flight holidays, as a transport aid in the car or for safe storage of your model aircraft in the home hangar.

Features:

• Hull width: 25 - 45 mm
• Dimensions (L/W/H): 100/50/80 mm

This hull or model holder is a smart solution to a vexing problem on the workbench or even when transporting round hulls. No more turning away and slipping off during maintenance and construction of such models. The opening width is variable over a wide range. Two can also be used. For example, a small holder at the stern and a larger one at the front for maximum stability. The rubbers also prevent slipping on the workbench. Supplied as a kit, which can be assembled in just a few steps. Notice. The legs are glued together. The small hole in which a toothpick can be used to help glue the individual legs together makes it easier to centre them neatly.

• Kit