WEMOTEC MIDI FAN EVO IMPELLER / HET 650-58-1760 COMPLETELY ASSEMBLED, FINELY BALANCED AND HARMONIOUSLY MATCHED
Product number:
9777423
Manufacturer number:
MDE 650-58-1760
Description "WEMOTEC MIDI FAN EVO IMPELLER / HET 650-58-1760 COMPLETELY ASSEMBLED, FINELY BALANCED AND HARMONIOUSLY MATCHED"
Modern multi-bladed impeller with high efficiency.
The impeller is supplied fully assembled with a HET 650-58-1760 engine.
The unit is factory tested, finely balanced and harmoniously tuned, so it can be used immediately.
The controller should be oversized by approx. 20% (in relation to the smaller controller value) due to continuous load.
LV = low Volt controller up to 6s, HV = high Volt controller from 7s
The battery should be rated at 1/15 - 1/20 of the current for 4-3 minutes full throttle without reserve.
- Diameter inside: 89,0 mm
- Outside diameter: 92.0 mm
- Length of housing: 60 mm, without lip
- Weight complete: 348 grams (+ opt. lip = 19g)
- Cross section: 49,40 qcm
- Rotor: 11-blade, nylon (gfk reinforced)
- Optimum nozzle: 75 mm diameter
- Timing controller: approx. 6° (4-pole motor)
- PWM: 8-12 kHz
About the measurement conditions:
was measured with stabilized voltage of 3.70 V / cell.
Current and thrust are based on measurement with small lip (r=6 mm) at 21° C, 50m above sea level and standard air pressure
The values may vary depending on the battery, controller and installation situation.
WEMOTEC is a manufacturer of high quality electric impellers with excellent efficiency for almost every conceivable application in model making. The rotors are carefully balanced. In the case of motor/impeller sets, the complete unit is finely balanced and harmoniously tuned, so it can be used immediately.
The impeller is supplied fully assembled with a HET 650-58-1760 engine.
The unit is factory tested, finely balanced and harmoniously tuned, so it can be used immediately.
The controller should be oversized by approx. 20% (in relation to the smaller controller value) due to continuous load.
LV = low Volt controller up to 6s, HV = high Volt controller from 7s
The battery should be rated at 1/15 - 1/20 of the current for 4-3 minutes full throttle without reserve.
- Diameter inside: 89,0 mm
- Outside diameter: 92.0 mm
- Length of housing: 60 mm, without lip
- Weight complete: 348 grams (+ opt. lip = 19g)
- Cross section: 49,40 qcm
- Rotor: 11-blade, nylon (gfk reinforced)
- Optimum nozzle: 75 mm diameter
- Timing controller: approx. 6° (4-pole motor)
- PWM: 8-12 kHz
About the measurement conditions:
was measured with stabilized voltage of 3.70 V / cell.
Current and thrust are based on measurement with small lip (r=6 mm) at 21° C, 50m above sea level and standard air pressure
The values may vary depending on the battery, controller and installation situation.
WEMOTEC is a manufacturer of high quality electric impellers with excellent efficiency for almost every conceivable application in model making. The rotors are carefully balanced. In the case of motor/impeller sets, the complete unit is finely balanced and harmoniously tuned, so it can be used immediately.
Box contents
- 1 x Laufrad Midi Fan pro, Einlauflippe
- 1 x HET 650-58-1760
- 1 x HET 650-58-1760