Description "WEMOTEC MINI FAN EVO IMPELLER / HET 2W16 COMPLETELY ASSEMBLED, FINELY BALANCED AND HARMONIOUSLY MATCHED"
Modern multi-bladed impeller with high efficiency.
This unit is a classic 3S drive.
The impeller is supplied fully assembled with a HET 2W16 motor. The unit is factory tested, finely balanced and harmoniously tuned, so it can be used immediately.
Measurement values at 3s
- voltage: 11.1 V
- Current: 51.0 A
- Power: 566 W
- Speed:
- Thrust: 9.8 N
- jet velocity: 52.16 m/s
- Efficiency: 0,45
- Controller: > 60A / LV
- Battery: 2.500-3.400 mAh
The controller should be oversized by approx. 20% (in relation to the smaller controller value) due to continuous load.
LV = low Volt controller up to 6s, HV = high Volt controller from 7s
The battery should be rated at 1/15 - 1/20 of the current for 4-3 minutes full throttle without reserve.
- Diameter inside: 69,0 mm
- Outside diameter: 72.0 mm
- Length of housing: 60 mm, without lip
- Weight complete: 147 grams (+ opt. lip = 15g)
- Cross section: 29,40 qcm
- Rotor: 9-blade, nylon (gfk-reinforced)
- Optimum nozzle: > 56 mm diameter
- Timing controller: approx. 12° (6-pole motor)
- PWM: 8-12 kHz
About the measurement conditions:
was measured with stabilized voltage of 3.70 V / cell.
Current and thrust are based on measurement with small lip (r=6 mm) at 21° C, 50m above sea level and standard air pressure
The values may vary depending on the battery, controller and installation situation.
WEMOTEC is a manufacturer of high quality electric impellers with excellent efficiency for almost every conceivable application in model making. The rotors are carefully balanced. In the case of motor/impeller sets, the complete unit is finely balanced and harmoniously tuned, so it can be used immediately.
This unit is a classic 3S drive.
The impeller is supplied fully assembled with a HET 2W16 motor. The unit is factory tested, finely balanced and harmoniously tuned, so it can be used immediately.
Measurement values at 3s
- voltage: 11.1 V
- Current: 51.0 A
- Power: 566 W
- Speed:
- Thrust: 9.8 N
- jet velocity: 52.16 m/s
- Efficiency: 0,45
- Controller: > 60A / LV
- Battery: 2.500-3.400 mAh
The controller should be oversized by approx. 20% (in relation to the smaller controller value) due to continuous load.
LV = low Volt controller up to 6s, HV = high Volt controller from 7s
The battery should be rated at 1/15 - 1/20 of the current for 4-3 minutes full throttle without reserve.
- Diameter inside: 69,0 mm
- Outside diameter: 72.0 mm
- Length of housing: 60 mm, without lip
- Weight complete: 147 grams (+ opt. lip = 15g)
- Cross section: 29,40 qcm
- Rotor: 9-blade, nylon (gfk-reinforced)
- Optimum nozzle: > 56 mm diameter
- Timing controller: approx. 12° (6-pole motor)
- PWM: 8-12 kHz
About the measurement conditions:
was measured with stabilized voltage of 3.70 V / cell.
Current and thrust are based on measurement with small lip (r=6 mm) at 21° C, 50m above sea level and standard air pressure
The values may vary depending on the battery, controller and installation situation.
WEMOTEC is a manufacturer of high quality electric impellers with excellent efficiency for almost every conceivable application in model making. The rotors are carefully balanced. In the case of motor/impeller sets, the complete unit is finely balanced and harmoniously tuned, so it can be used immediately.
Box contents
Scope of delivery:
1 x Impeller Mini Fan evo, inlet lip
1 x HET 2W16
1 x Impeller Mini Fan evo, inlet lip
1 x HET 2W16