Brushed electric motors of „FOXY Brushed“ range are perfect for a whole lot of model builder's applications - for powering aircraft, boat, car, tank and other ground vehicle models either with direct drive or with a gearbox.
When connecting and installing foxy motors, pay attention to the allowed voltage and load current limit.

Motor cooling: operating temperature of the housing shouldn't exceed 80°C. The model should always have sufficient air intake and air-flow around the motor. For boat models, we recommend using water cooling. High motor loads are possible only for short periods. After every driving/riding/flying session, you should let the motor cool down to a room temperature before the next ride/flight/drive.

FOXY 250 7.2 V is a brushed electric motor size "250" with a shaft with a diameter 2.0mm and plain bearings. It is suitable for powering indoor aircraft models or park flyers with direct drive (4.7x2.3" or 4x3" propeller) or with a gearbox for a small car and boat models.

For controlling the RPM, you will need an ESC with a load capacity of 8–12A.

FOXY 280 7.2V is a suitable replacement for a motor SPEED 280 7.2V (product number 7301).

Set contains:

• Brushed electric motor FOXY 280 7.2V
• User manual

Specifications:

• Voltage [V]7.2
• Voltage [V]3.7 - 7.4
• RPM at rated voltage [ot./min]15500
• ESC [A]8 - 12
• Diameter [mm]23.8
• Length [mm]30.5
• Shaft diameter [mm]2
• Free shaft length [mm]12
• Weight [g]42