Please be aware that this product can only be shipped to the following countries: Austria, Germany, Switzerland, Belgium, Bulgaria, Croatia, Czech Republic, Denmark, France, Greece, Hungary, Italy, Luxembourg, Netherlands, Norway, Poland, Portugal, Romania, Serbia,  Slovakia, Slovenia, Spain, and the United Kingdom!

PARTALL® Coverall Film is a film-forming release agent based on polyvinyl alcohol (PVA) and water, it does not contract and thus remains uniform even on corners or curved surfaces. It is readily biodegradable and is not a hazardous material under current occupational health and safety and transportation regulations.

Suitable for epoxy and polyester resins. Dyed violet for better processing.

• Silicone free
• Water soluble
• Heat resistant up to approx. 100 °C

Processing:
PARTALL® Coverall Film is supplied ready for use and should not be diluted. It is to be applied by means of a spray gun or a brush/sponge. Further processing information in the technical datasheet

PARTALL® Coverall Film is suitable in combination with release agent Semiperm™ Monofilm as a safe release agent for silicone moulds. This combination provides a barrier layer so that casting with epoxy resins is also possible without any problems. The service life (durability) of the moulds is significantly extended.

The release agent Semiperm™ Monofilm is applied with a brush. After flash-off, an application of PARTALL® Coverall Film PVA is made, also with a brush or sponge. The PARTALL® Coverall Film PVA transfers to the casting are washed off with water after demolding and reapplied before each impression.