• Description


16Wx2 Navigation & Strobe, 11mm, T-Fuse

Powerful position and flash light in one housing. The profile light of the 11mm series is very slim on the outside and also fits smaller models. Due to its powerful LED emitters, however, it has a high light output despite its compact dimensions and is therefore also well suited for larger models. The new, inwardly displaced cooling surface allows surprisingly compact dimensions with a uniquely slim design.

The profile-shaped polycarbonate cap is only attached when delivered. This can be painted separately, is highly transparent and burchfest. The installation of the lamp is surprisingly simple: With a simple surface mounting only one slot 3x28mm is necessary, therefore the lamp can also be mounted on small edge arches or fuselage backs. On request, the luminaire can also be recessed up to 4mm and is available in an even smaller design. The cap must be glued after final assembly.

The luminaire is ready-made for operation with 2S Lipo (approx. 8V). When operating with 3S (12V) the enclosed resistor must be used, alternatively you can also use a 4W-3S adapter cable. Please note that high-power LEDs can become very warm, up to 70°C is quite normal. These luminaires with heat sink housings are suitable for continuous operation if an air flow (in flight) is possible. If this is not the case, then switch-on times of 5-10 should not be exceeded. Check the operating temperatures after installation.

Technical data

Referenzleistung 8Wx2 ROT/8Wx2 WEISS
Spannung 8(12)V
Stromstärke 2x0.7A
Abstrahlwinkel >160°
Lichtstärke ca.200/400 Lumen ROT/WEISS
Abmessungen 11.5x42.5x70mm (ohne Kabel)
Gewicht 13g (ohne Kabel)

Box Contents

  • 16Wx2 Navigation & Strobe, 11mm, T-Fuse
  • 1m silicone cable and ready-made series resistor for 2S operation and resistor for 3S included


Often bought together

Notification for this product