• Description

Description

Description

4W point light with two clear polycarbonate caps (10mm and 24mm).The module is supplied pre-wired with an aluminum mounting plate for cooling and Monday. Also included is another small heat sink for alternative mounting with very small dimensions.

All you have to do is apply the desired cap and heat sink with superglue. The 10mm cap serves as light distribution for concealed installation behind a GRP wall, the 24mm cap can be used for outdoor installation, as it completely covers the module. Accessories include a polycarbonate profile extension that can optionally be glued to the 10mm cap.

Please note that high-power LEDs can become very warm, up to 70°C is quite normal. However, these modules are only suitable for continuous operation if a heat sink is used. After installation, check the operating temperatures and use our heat sink housings, for example.

Information on the reference power is a pure comparison value between the lamps offered. They normally refer to an operating voltage of 12V/3S Lipo and depend on lamp, operating mode and technology.

Pay attention to the operating temperature, the manufacturer does not assume any warranty for overheating.

Attention: The LED lights are extremely bright! Never look directly into an LED!

Technical data

Reference power 4W
Voltage [V] 8V(12V)
Current [A] 0,35A
angle of reflected beam ~160°
Luminosity ~100 Lumen
Dimensions baseplate [mm] 10x50mm
Weight 6g (ohne Kabel)
Small cap 15x15x6mm, selbstklebend
Big cap Ø10x12mm + Profilerweiterung
Große Kappe Ø24x10mm

Box Contents

  • round light 10/24mm, 4W (white)
  • with 1m connection cable
  • Pre-assembled series resistor for 2S
  • resistor for 3S included



Videos

Comments

Often bought together

Notification for this product