• Description

Description

Description

dot LED chip in RED

High-power LED module with 4W reference power. Pre-assembled for operation with 2S Lipo (approx. 8V). When operating with 3S (12V), the enclosed resistor must be used. Alternatively, you can also use a 4W-3S adapter cable.

Please note that high-power LEDs can become very warm, up to 70°C is quite normal. However, these modules are only suitable for continuous operation if a heat sink is used. After installation, check the operating temperatures and use our heat sink housings, for example.

Information on the reference power is a pure comparison value between the lamps offered. They normally refer to an operating voltage of 12V/3S Lipo and depend on lamp, operating mode and technology.

Pay attention to the operating temperature, the manufacturer does not assume any warranty for overheating.

Attention: The LED lights are extremely bright! Never look directly into an LED!


Technical data

Reference power 4W
Voltage [V] 8V(12V)
Current [A] 0,35A
angle of reflected beam ~140°
Luminosity ~50 Lumen
Dimensions [mm] Ø20x7mm/Chip Ø8x5mm
Weight [g] 2g (ohne Kabel)

Box Contents

  • dot LED chip (red)
  • with 1m connection cable
  • Pre-assembled series resistor for 2S
  • resistor for 3S included


Comments

Often bought together

Notification for this product