WELLPOWER LIPO BATTERY PACK SE V2 1500 MAH / 11,1 VOLT 3S

Hints!

Please be aware that this product can only be shipped to the following countries: Austria, Germany (except Wellpower-CHECK), Switzerland, Slovakia, France, Italy, Belgium, Bulgaria, Denmark, Finland, United Kingdom, Croatia, Luxembourg, Netherlands, Poland, Romania, Sweden, Slovakia, Slovenia, Czech Republic and Hungary!

"WELLPOWER" Lipo batteries with the sensational price, performance ratio! "SE" series = high-quality workmanship + outstanding performance data + best price-performance ratio! Depending on type -100C loadable (peak current) and charging currents of up to 8 times the nominal capacity make our "Wellpower" Lipos the first choice for the ambitious model builder. Balancer plug system "XH". Version "V2" is supplied as standard with a Liposafe specially manufactured according to battery size (from 1000mAh). For maximum safety during transport and storage. The battery and Liposafe can even be installed directly in the model. (Note temperature development!). For price-conscious model builders we offer the "ECO" series especially, with somewhat lower nominal load capacity and without Liposafe, but with the well-known quality features at an unbeatable price. Splitpack´s have two balancer and 4 main power connections. Version "ULTIMA" with real 35C or 60C continuous load and peak between 70C and 90C (1sec.) or 120C (max.0,5sec.) for uncompromising applications like e.g. in competition. "CHECK" version with standard built-in LED voltage indicator for quick test of battery charge status.
Discharge currents "SE/V2": The values in brackets are only valid for short-term load! (max. 5 seconds)
Charge currents: "CHx" Data indicate the maximum permissible charge current. For CH2, for example, twice the value of the rated capacity (i.e. max. 4A for 2.0Ah battery), CH6 six times the value, etc.

Tip:
- The max. continuous discharge current is only recommended with active temperature monitoring!
- Preheating cold batteries increases performance and service life
- Never allow batteries to become hotter than 60°C.
- Recommended bearing voltage 3,70... 3,80 V / cell
- Protect from short circuit, mechanical damage, overheating, deep discharge and overcharging.
- Only charge with a suitable lipolader on a fireproof surface.
- Do not continue to use damaged cells !
- never charge or discharge unattended !

Comments