• Description


Powerful and fast, universal digital servo with double ball bearing metal gear. Low height, only 24.9mm high. The first servo of a new generation of programmable digital servos from Futaba. Suitable for operation with 2 LiPo cells. The servo is connected to a USB interface of the PC via a separate adapter and programmed. In addition to the usual settings such as servo travel, end points, polarity reversal and servo center, the starting characteristic and the servo speed can also be set. The new system is ideally equipped for future developments. For future applications it is possible to assign an address (ID) and channel number to the servo.

The following functions can be set:
  • Servo center adjustment +/- 300?s (approx. 30 degrees)
  • Servo speed 0.36-9 seconds per 45°.
  • Deadband setting
  • End point adjustment left and right separately approx. 50-175%
  • anti-flatter filter
  • Servo polarity
  • Servotype Standard retractable undercarriage
  • Smoother - hard starting behaviour
  • Mode selection on signal failure Free-hold
  • Soft servo run
  • ID storage
  • channel allocation

Futaba Servos have enjoyed great popularity for years due to their high quality and many innovative solutions. The servo line includes servos for almost every application in model making. Many servos are designed without internal wiring. Futaba servo gearboxes are characterized by unsurpassed precision. In some servos, bell-shaped armature motors are used for powerful, fast and powerful servos. Digital servos with microprocessor technology offer higher holding power, shorter response times and 4 times the pulse rate compared to conventional servos. BLS/Brushless motor technology: no brush wear, 30% shorter reaction time, more resistant to vibration and shock, higher efficiency and higher resolution, same power consumption. S-BUS technology with following advantages: fewer cables, lower weight, lighter weight, easier cable routing, easy parallel connection of servos. S. BUS servos can also be operated at the normal PWM receiver output. HV servos can be operated directly with 2S Lithium batteries in the voltage range of 6... 7.4 volts. Due to the higher voltage, the power consumption is lower with the same servo power.

Technical data

Bearing ••
Gearbox Type Metal
Torque 6,0 kg
Speed(45°) 0,11
Weight (g) 32 g
Length (mm) 35,9
Width (mm) 19,5
Height (mm) 24,9
Servo type Digital
Gear tooth


Often bought together

Notification for this product