• Description

Description

FEATURES
- Powerful S.BUS2 digital servo with metal gearbox
- SR mode
- Hi-Voltage
- Coreless engine
- Ball bearing
- Titanium output gearwheel
- Robust aluminium-plastic housing
- High resolution
- High return accuracy
- Low-wear potentiometer
- Water-protected

TECHNICAL DATA
- Operating voltage: 4.8 - 8.4 V
- Actuating speed 60° (7.4 / 6.6 V): 0.06 / 0.09 s
- Actuating torque (7.4 / 6.6 V): 24.6 / 21.6 kgcm
- Control frequency: 50...300 Hz
- Dimensions: 40,5x21x37,2 mm
- Weight: 70 g

DESCRIPTION
Programmable Car-Servo in Hi-Voltage S.BUS2 version with metal gear and aluminium housing middle part. Specially designed for use in 1/8 OffRoad Buggies & Truggies.

Programmable through S.BUS2 technology! Of course, all S.BUS2 servos can be connected to conventional receivers with PWM modulation. The addressing of the servos can be done in different ways:

1. via the S.BUS receiver
2. with the handy programmer SBC-1
3. via the PC-Link software with the USB adapter CIU-2
4. at the S.BUS connection of the transmitter

The following parameters can be configured:
- S.BUS channel assignment
- servo reversal
- Servotype (Normal / retractable)
- Soft start (On / Off)
- Mode selection in case of signal failure Hold or Free
- Soft servo run (on / off)
- Servo position (servo tester)
- Servo center adjustment +/- 300 µs (approx. 30 degrees)
- Servo speed, 0.39...9 seconds per 45 degrees.
- Deadband setting (dead band)
- Servo travel adjustment left and right separated, approx. 50...175%
- starting force
- attenuation
- holding force
- ID storage

Hint:
In order to use the speed of the Futaba SR system, many FUTABA SV servos can be switched to SR mode via T7PX or T7XC transmitter. Currently the following servos are SR compatible:
BLS371SV, BLS471SV, BLS571SV, BLS671SV, BLS671SVi, BLS373SV, S9372SV and S9373SV.

Technical data

BB
Gearbox type
Torque (6V)
Speed (60°)
Weight
L/W/H [mm]
Servo-type Digital

Comments

Last viewed article

Notification for this product