PARTALL® Hi-Temp Wax
is a PTFE-containing release wax formulated for use in high-heat applications up to 350 °F (177 °C). Especially useful in applications where standard silicone waxes hinder post-finishing operations.
Hi-Temp Wax is a high-temperature release agent of modern, synthetic microcrystalline waxes and Teflon® (polytetrafluoroethylene). Yields high-gloss surfaces. Ideal for smooth, tight surfaces e.g. on GRP moulds. Polishing properties after a drying time of approx. one minute.Application instructions of the manufacturer:
Rub wax thoroughly onto the clean surface of mould. Allow the wax to remain on mould until moderately dry (the wax will appear hazy). Buff with clean towelling, we recommend our cleaning and polishing cloth (item no. 365-SHT) until a clear high gloss appears. Rebuff the entire mould surface with cleaning towelling. Note: Use 2 to 3 coats of wax on the first application only. Re-wax and buff as necessary.Consumption:
20-60 g/m2 (quantity depends on the condition of the mould surface)Important note on substrates:
This product contains solvents based on hydrocarbons (see under Additional Information --> Safety Data Sheet). It also contains a small amount (< 2 %) of aromatic hydrocarbons. Some surfaces made of plastic (e.g. polycarbonate, Plexiglas®, various varnishes, putties) are dissolved by it so that an impression cannot be taken. It is essential to check this before use, either by referring to resistance lists for the materials or by carrying out a preliminary test.
For sensitive surfaces, we alternatively recommend PARTALL® Coverall Film PVA from Rexco.
2.2 Label elements
Labeling according to the Globally Harmonized System (GHS)
Signal word : Danger