Drop-shaped combined light module in white/green or white/red. Used, for example, as position and anti-collision lighting (strobe).

variant description

• White/green variant: For use e.g. as green position light and white collision warning light (strobe) in the wingtip on the starboard side (right).
• White/red variant: For use e.g. as red position light and white collision warning light (strobe) in the wingtip on the port side (left).

connector

The combi light module can be connected directly to two SLC outputs (Smart Light Channel) of the Light Driver 5.0 lighting control system (see accessories). No soldering work and no series resistors are necessary.

Intelligent lighting control

• Plug & Play type recognition: The combined lighting module is automatically recognised by the Light Driver 5.0 lighting control system. The light control regulates the luminosity and thus the heat development according to the thermal properties of the module housing.
• MLT technology (Maximum Light Tracking): The light module can optionally be operated at full light output. An integrated heat sensor enables the Light Driver 5.0 lighting control system to automatically regulate the light output in the event of high heat generation.

interoperability

The light module can also be used in conjunction with the Optotronix light control modules. For this purpose, a 2.7 Ohm resistor (2R7) for the green or white version and a 5.6 Ohm resistor (5R6) for the red version must be soldered into the positive or negative cable.